Kemp High Availability Feature Description And Operation Manual page 35

High Availability (HA)
Feature Description
33. Check that the Interface Address (address[/prefix]), the HA Shared IP address and HA
Partner IP address are correct before adding it to the production unit.
34. In the main menu, go to Local Administration > HA Parameters.
35. Ensure that the HA Virtual ID is correct.
36. When new unit 1 (C) is connected, open the WUI of the shared IP address and in the
main menu, go to System Configuration > Miscellaneous Options > HA Parameters.
37. Click Force Update.
38. This will take approximately 15 seconds.
39. When the update is complete, in the main menu, go to System Configuration >
Miscellaneous Options > HA Parameters.
40. In the Switch to Preferred Server drop-down list, switch the preferred host to the other
unit or select No Preferred Host.
Preferred master set to none
Current setup – two units in production
If you were replacing faulty units, ensure to send the old faulty units back to
Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved.
Figure 10-10: HA Virtual ID
Figure 10-11: Force Update
New unit 1 (C) (Standby)
Old unit 1 (A)
KEMP for testing.
New unit 2 (D) (Master)
Old unit 2 (B)
Page 35 / 37