Table of Contents
Advertisement
High Availability (HA)
Feature Description
6. Specify the desired shared IP address in the HA Shared IP address field and click Set
Shared Address.
7. A confirmation message may appear. Click OK.
8. A message may appear asking to reconnect to the shared IP address. Click OK.
9. Enter the IP address of the passive (slave) unit in the HA Partner IP address and click the
Set Partner address button.
10. A confirmation message will appear. Click OK.
11. Configure any other settings as needed.
12. Click Reboot Now.
13. Click Continue.
14. Refresh the page after the LoadMaster has rebooted (this may take a few minutes).
A log in screen appears. After logging in, a different menu will appear than
before. This is the Local Administration menu displayed for HA units.
This menu has far fewer options. Only configuration settings pertaining to
that specific unit are accessible via the Local Administration option. All
management of the HA units should be done via the shared IP address. To
see the full menu and configure the units, access the WUI of the shared IP
15. Log in to the shared IP WUI by entering the shared IP address in the address bar of the
browser and pressing Enter.
In the top-left of the screen there will be 2 indicator squares.
status of the HA pair. The left square always represents HA1 and the right represents HA2. The A
represents which unit is active. The first or second HA unit can be opened by clicking the
relevant status icon. Green and green status colors indicate a properly paired configuration.
Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved.
Do not reboot or reconnect at this time.
Figure 5-5: Rebooting message
Figure 5-6: Log in screen
address, which was specified above.
These squares indicate the
Page 11 / 37
Advertisement
Table of Contents
