Philips FWM589 Service Manual page 3

SPECIFICATIONS
GENERAL:
Mains voltage : 110-127V/220-240V Switchable
for /21/21M
: 230 ± 10% for /22/30
: 120 ± 10% for /37
Mains frequency : 50/60Hz
Power consumption : < 1W at ECO Power Standby
: < 25W at Standby (DEMO mode off)
: 175W at Active
Clock accuracy : < 4 seconds per day
Dimension centre unit : 265 x 322 x 390mm
TUNER:
FM
Tuning range
Grid
IF frequency
Aerial input
Sensitivity at 26dB S/N
Selectivity at 600kHz bandwidth
Image rejection
Distortion at RF=1mV, dev. 75kHz
-3dB Limiting point
Crosstalk at RF=1mV, dev. 40kHz
MW
Tuning range
Grid
IF frequency
Aerial input
Sensitivity at 26dB S/N
Sensitivity at S9/300KHz
IF rejection
Image rejection
Distortion at RF=50mV, M=80%
AMPLIFIER:
Output power (6 Ω, 1kHz, 10% THD)
L & R
Frequency response within -3dB
MAX Sound
Game Sound
Dynamic Bass Boost (DBB)
Digital Sound Control (DSC)
Virtual Ambience Control (VAC) : Cyber / Arcade / Hall /
: 87.5-108MHz
: 50kHz
100kHz for /37
: 10.7MHz ± 25kHz
: 75 Ω coaxial
300 Ω click fit for /37
: < 7µV
: > 25dB
: > 25dB [> 75dB]
: < 3%
: < 8µV
: > 18dB
: 531-1602kHz
530-1700kHz for /21/21M/37
: 9kHz
10kHz for /21/21M/37
: 450kHz ± 1kHz
: Frame aerial 18.1µH
: < 4.4mV/M
: > 18dB
: > 45dB
: > 28dB
: < 5%
: 2 x 200W RMS /21/22/30
: 2 x 160W FTC /37
: 63Hz-16kHz
: On / Off
: Speed /Punch /Blast /Off
: DBB 1, 2, 3 & Off
: Jazz /Rock /Pop /Optimal
Cinema / Concert
1-3
Input sensitivity
Aux in (at 1kHz) : 640mV ± 2dB
Game Port (at 1kHz) : 310mV ± 2dB
USB (at 1kHz) : 830mV at 600 Ω
Output sensitivity
Headphone output at 32 Ω : 700mV ± 2dB (Max. vol.)
5DTC:
Measurement done directly at the connector on the board.
Output Resistance
Output Voltage (0dB, 1kHz)
Channel Unbalance
Channel Separation (1kHz)
Frequency Response (±3dB) : 20Hz-20kHz
Signal to Noise Ratio
MP3-CD Bit Rate
Sampling Frequencies
USB:
Measurement done directly at the connector on the board.
Output Impedance (1 kHz)
Output Voltage (0dB, 1kHz)
Channel Unbalance
Distortion THD (0dB, 1kHz)
Channel Separation (1kHz)
Frequency Response (±3dB) : 20Hz-20kHz
Signal to Noise Ratio
[....] Values indicated are for "ECO6 Cenelec Board" only.
: < 100 Ω
: 0.5Vrms ± 1dB (unloaded)
: < ±1dB
: > 60dB
: > 75dBA
: 32-256 kbps
: 32, 44.1, 48 kHz
: < 1.5 kohm
: 830mVrms ± 1.5dB
: < ±1dB
: < 0.3%
: > 35dB
: > 60dBA