10
Installation
CONTROL CONNECTIONS
For each actuator, run (2) wires, 5 to 25 feet long of 14 gauge wire for power. Use (3) wires 16 to
20 gauge for the controls. If using (2) actuators, use motor cables of the same length and gauge
to ensure the motors run at the same speed.
NOTE: When actuator wiring is run to the bottom of the operator, mount using this hold
(! -- see Figure 8) to prevent plate from shearing cables.
WARNING
If operator does not stop in time, the plate may cut the cable.
Doc 01-G0399
Rev A
0 1 -g 0 3 0 9 9 F2 2
Figure 8