Sanyo PLC-XP18N Service Manual page 16

)f the tamp faHs to come on and the tamp reptacement indicator on
the projector tight is orange, you must replace the lamp.
^ For continued safety, rep)ace with a !amp assembly of the same type.
part NO. 6102822755
^ AHow the projector to coo! for at ieast 45 minutes before you open the tamp
cover. The inside of the projector can become very hot.
^ Do not drop the tamp modute or touch the giass bu)b! The glass can shatter and
cause injury.
^ Fotbw these steps to roptace the tamp assembty.
1. Turn off the projector and at)ow the projector to coof thoroughty.
2. Disconnect the AC cord from the projector.
3- Remove screw with a screwdriver and remove the tamp cover.
4. Remove 2 screws wrth a screwdriver and pu!) out the tamp assemb)y
by grasping the handte.
5. Repiace the )atDp assemb)y.
6. Tighten 3 screws to secure the tamp cover to the tamp assemb)y.
7. Connect the detachaMe AC cord to the projector.
8. Reset the tamp repfacement monitor timer. (Refer to next page.)
^ Turn off. Remova AC cord and watt 46 minutes before open this tamp cover.
" ^ Refer owner'a manua) for replacing the tamp. Rep)ace wnh Mme type tamp.
A EtaindreFapparoi). Entente Cordon aacteur at sttandra 46 minutes avant
/ ^ \ d'ouvrtr ce couvefcte.
Sa mportar au fnodg d'amptoi pour ramptacer ta ttmpa. Remptacar ta fampe
par un modef identique.
A Schahen Se den Projaktor aus, ziehen Sie dss Stromkabe) aus dem Projektor
/!\ und warten Sie 46 Mfnuten. bavor Sta den Protetctor <trfner).
LeMn Sie im Manua) im KapiM) "Lampertwachse)'' die Detaits nach.
Banutzen Sie nur aine offiziette Ersatztampe dea giaichen Typs. ^
A Apague wt aparato. DMConecte a) cabta da rad y aapera 45 mintftos amos
/t\ da abrirfa tapa-
Consuha e) manuat do instfucctonM para cambiar ta tampara.
Csmbie )a )ampafa por otra da) misfno tipo.
A St^ng BV projektom. Dra ur Kiontdtten och va)m 46 minu^r innan Mi 6ppnar
/J\ aftyddet. Vt MnvJMf tit) !nMtu)c6onsbottan innan M bytar )ampa.
Anvand samma typ av )ampa-
A S<uk ^r projektoren. Fjam nettedningen fra sdkkontakten og vent ^5 rrMn..
/!\ far ktbinettet abnes- Se i bnjga'nvisninoen, far )ampan skiftaa.
BfugzatDmetypetampe. n
Lamp
Assembty
Lamp cover
WARNtNG
ALLOW TO COOL BEFORE ATTEMPTING
TO CHANGE THE LAMP.
USE ONLY REPLACEMENT LAMP PART
N0-6102822755
t6