Toshiba e-STUDIO5540C Management Manual page 160

2 SETTING ITEMS (ADMIN)
3
Press the desired Ethernet speed button, then press [OK].
For e-STUDIO6550C Series, e-STUDIO4540C Series
When you select a specific Ethernet speed, you must select the same Ethernet speed as set in the
connected network. If you do not know the Ethernet speed that must be used, select [AUTO].
The current Ethernet speed is displayed above the buttons. "Link not detected" is displayed when links
failed to be detected.
If the network is not stable, power OFF the equipment and then power it back ON.
For e-STUDIO456 Series, e-STUDIO856 Series, e-STUDIO306LP
When you select a specific Ethernet speed, you must select the same Ethernet speed as set in the
connected network. If you do not know the Ethernet speed that must be used, select [AUTO (-100MB)] or
[AUTO (-1000MB)].
This equipment does not enter the Super Sleep mode even if [ENABLE] is selected in the SLEEP/SUPER
SLEEP screen when ETHERNET is set to [AUTO (-1000MB)] or [1000BASE FULL].
The current Ethernet speed is displayed above the buttons. "Link not detected" is displayed when links
failed to be detected.
If the network is not stable, power OFF the equipment and then power it back ON.
158 Setting Network Functions