Philips DVDR3350H Service Manual page 13

7. Remove the Upgrade Disc and press <OK> button to confi rm.
8. The TV screen goes blank, tray close and after a while the Philips Logo screen appear again.
9. Press <Tuner> and <Setup>.
10. In "SETUP MENU – HDD", select "Delete HDD" and press <OK>
11. The TV connected to the set will display:
All video programs on the HDD will be deleted
Press OK to continue.
12. Press <OK> button to confi rm deleting. (Use the left/right button for selection)
The whole process takes less than 15 minutes.
Note: Do not press any button or interrupt the mains supply during the upgrading process, otherwise the set may becomes defective.
13. When the upgrading process is successful, the set will go into Standby Mode.
Note: All existing channels will be lost.
D. Procedure to apply the SERVO fi rmware upgrade:
1. Power up the set and open tray.
2. Insert the prepared Upgrade CDROM and close the tray,
3. The TV connected to the set will display:
Software Upgrade Disc detected
Select OK to start or CANCEL to exit
4. Press <OK> button to confi rm upgrading (use left/right button for selection)
5. The TV connected to the set will display:
Upgrading Software, Please wait
Do not switch off the power
The whole process takes less than 15 minutes.
Note: Do not press any button or interrupt the mains supply during the upgrading process, otherwise the set may becomes defective
6. When the upgrading process is successful the tray will open and the TV connected to the set will display:
Loader upgrade process has completed successfully.
Press OK to reboot the system.
7. Remove the Upgrade Disc and press <OK> button to confi rm
8. The TV screen goes blank, tray close and after a while the Philips Logo screen appear again.
E. How to read out the fi rmware version to confi rm upgrading.
1. Power up the set and press <SETUP>.
2. Press <321> and <SELECT> buttons on the remote control.
3. Press <OK> to exit.
5.2 Procedure for replacing a new HDD:
1. Replace the faulty HDD with a new HDD.
2. Power up the set and open tray.
3. Insert HDD fi rmware upgrade disc and follow "Procedure to apply the HDD fi rmware upgrade" (See 5.1 C).
The whole process takes less than 15 minutes.
Note: Do not press any button or interrupt the mains supply during the upgrading process, otherwise the set may becomes defective.
4. When the HDD upgrading process is successful, the set will go into Standby Mode.
5. To upgrade the set, follow Firmware Upgrading. (See 5.1)
Upgrade Software & Repair Chart 3139 785 31500 5. EN 13