Advertisement
OPERATIONS
Attaching the remote controller
• Do not place the remote controller where it will be exposed to direct sunlight.
PHASE AND SOUND ADJUSTMENT
Use a CD with rich bass sound to test and adjust phase and sound.
Main Unit
When your car receiver is equipped with
Low Pass Filter, switch to "OFF."
Switch to the position (+/–) which
gives you better sound.
TROUBLESHOOTING
For more details, consult JVC IN-CAR ENTERTAINMENT car audio dealer.
No sound is heard.
• Is the blue with white stripes connected correctly?
• Is audio cord connected to the LINE IN jacks?
• Is this subwoofer system grounded?
Alternator noise is heard.
• Keep the power cord away from the audio cord.
• Keep the audio cord away from other electrical cables in the car.
• Confi rm if the ground wire is connected securely to a metal part of the car.
• Confi rm if the noise originates in the receiver.
Cautions
• When using this unit, deactivate all sound adjustment functions except volume level;
otherwise, sound may be distorted.
Remote Controller
Turns on and off the subwoofer
output. When it is on, the lamp
lights up.
SPECIFICATIONS
Type
Speaker Unit
Input Terminal
Power Output
Signal-to-Noise Ratio
Maximum Amplifi er Power Output
Cut-off Frequency
Crossover Frequency
Sound Pressure Level
Level Control
Power Requirement
Dimensions (W/H/D)
Mass
Supplied Accessories
Design and specifi cations are subject to change without notice.
4
Adjust the subwoofer output level.
(Center: 0 dB)
Closed Active Subwoofer (Built-in amplifi er)
14 cm (5-
9
/
in.) cone
16
LINE IN (1 system), 0.19 V/25 kΩ
SPEAKER (1 system), 3.7 V
32 W RMS x 2 channels at 2 Ω
and ≤ 1% THD + N
75 dBA (reference: 1 W into 2 Ω)
60 W + 60 W (Impedance 2 Ω + 2 Ω )
110 Hz (L.P.F. switch "ON", –12 dB/oct low pass fi lter)
20 Hz to 200 Hz (L.P.F. switch "ON")
20 Hz to 500 Hz (L.P.F. switch "OFF")
88 dB/ m (with line input: 0.03 V)
–50 dB to 0 dB (Center) to + 10 dB
DC 14.4 V (11 V to 16 V allowance)
Negative ground
290 mm × 60.5 mm × 200 mm
(11-
/
in. x 2-
/
in. x 7-
/
in.)
7
7
7
16
16
8
2.1 kg (4.7lbs) (Excluding accessories)
Remote controller (cord: 3 m/9.8 ft.) × 1
Power cord (3 m/9.8 ft.) × 1
Stay (Metal tool ) × 4
Tapping screw ( 4 × 16 mm/
11
/
in.) × 4
16
Mounting screw ( 4 × 20 mm/
13
/
in.) × 4
16
Velcro tape × 4
Double-sided tape × 1
Crimp connector × 1
Wire clamp × 1
Advertisement
