Electrical Adjustment - Sanyo VPC-HD2 Service Manual

3. ELECTRICAL ADJUSTMENT

3-1. Table for Servicing Tools
Ref. No. Name
J-1 Pattern box
J-2 Calibration software
J-3 Chroma meter
J-4
Spare lump
J-5 Discharge jig
J-6
Collimator
Spare lump (collimator)
J-7
Download the calibration software and the firmware
from the following URL.
http://www.digital-sanyo.com/overseas/service/
J-1
J-4
3-2. Equipment
1. AC adaptor
2. PC (IBM R -compatible PC, Pentium processor, Window
98 or Me or 2000 or XP)
3-3. Adjustment Items and Order
1. Lens Adjustment
2. AWB Adjustment
3. CCD White Point Defect Detect Adjustment
4. CCD Black Point And White Point Defect Detect Adjust-
ment In Lighted
Note: If the lens, CCD and board and changing the part, it is
necessary to adjust again. Item 1-4 adjustments should be
carried out in sequence.
Part code
Number
VJ8-0190
1
1
1 VJ8-0192
1 VJ8-0191
1 VJ8-0188
1 VJ8-0260
1 VJ8-0282
J-3
J-5
3-4. Setup
1. System requirements
Windows 98 or Me or 2000 or XP
IBM R -compatible PC with pentium processor
USB port
40 MB RAM
Hard disk drive with at least 15 MB available
VGA or SVGA monitor with at least 256-color display
2. Installing USB driver
Install the USB driver with camera or connection kit for PC.
3. Pattern box
Turn on the switch and wait for 30 minutes for aging to take
place before using Color Pure. It is used after adjusting the
chroma meter (VJ8-0192) adjust color temperature to 3100 ±
20 K and luminosity to 900 ± 20 cd/m
the lump and its circumference are high temperature during
use and after power off for a while.
4. Computer screen during adjustment
Calibration Upload
AWB
Firmware
Focus
Data
UV Matrix
Cal Mode
PAF Cal.
OK
EVF
Cal Data
LCD Type
OK
USB storage
Get VID
PID
Set
Backrush pulse :
Get
3-5. Connecting the camera to the computer
1. Connect the cable adaptor to the camera.
2. Insert the USB cable to the USB/AV terminal of the cable
adaptor.
3. Locate a USB port on your computer.
4. Insert the AC adaptor's cable to the DC IN terminal of the
cable adaptor.
5. Turn on the camera.
6. If "USB CONNECTION" is displayed, choose the "COM
PUTER", and press the SET button.
Next, choose the "CARD READER", and press the SET
button.
– 17 –
2
. Be careful of handling
LCD
R Bright
B Bright
RGB Offset Gain
Tint Phase
VCO
H AFC Test
Set Serial Set
Set Rev. Set
Set
VCOMDC
VCOMPP
Hall Cal.
Setting
Language
Video Mode
Factory Code