Table of Contents
Advertisement
9.2.4.
Slide Cam
1. Perform the step "9.2.3. Pulley Gear, Belt".
2. Disconnect the 3 FFCs.
3. Remove the 2 Screws (B) and the Angle.
4. Peel off Coppery Sheet from FFC (A) and remove the
Drive P.C.B.
5. Before open the connector lock, make sure to weld the
short circuit solder of the OPU, and then disconnect the
OPU FFC.
6. Remove the 2 Screws (C), and remove the Traverse
Base Ass'y with spreading the 2 hooks to the direction of
arrows.
7. Remove the Slide Cam.
9.2.5.
Mid Gear, Drive Gear and Loading
Motor
1. Perform the step "9.2.4. Slide Cam".
2. Remove the Mid Gear and Drive Gear.
3. Remove the Screw (D) to remove the Loading Motor.
4. Remove the Screw (E).
Remove the 2 soldering points, and remove the Loading
Motor and the SW P.C.B..
32
Advertisement
Table of Contents
