4. Insert the Paper clips, etc. into the hole of the Tray at 45
degrees, and lean it to the direction of arrow with pushing
the dotted point of the tray forward.
Then the one side of the tray is come off from the Drive.
5. Insert the Paper clips, etc. into the Tray as below figure,
lift up the lever using the Paper clips, etc. while pushing
the dotted point of the Tray.
And remove the Tray.
9.2.3.
Pulley Gear, Belt
1. Perform the step "9.2.2. Tray".
2. Push the Post to the direction of arrow by using the slot-
ted screwdriver.
3. Remove the Pulley Gear and Belt.
31