Gigabyte GA-X99-UD4 User Manual page 28

10) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Intel
RAID 5, and RAID 10. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring
a RAID array.
DEBUG
PORT
11) sSATA3 0/1/2/3 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standards. Only AHCI and IDE modes are supported. Each SATA connector supports a single SATA device.
DEBUG
PORT
Hardware Installation
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Chipset\PCH SATA
Configuration," for more information.
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Chipset\PCH sSATA
Configuration," for more information.
S _
SATA3 3 2 1
5 4 0
7
7
Pin No. Definition
1 GND
S _
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
3 1
sSATA3
2 0
7
7
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
- 28 -
B_
Chipset supports RAID 0, RAID 1,
®
1
1
1
1