Do you have a question about the EY15V and is the answer not in the manual?
Questions and answers
Farhad
May 10, 2025
Hi not start
1 comments:
Mr. Anderson
May 20, 2025
The Robin EY15V may not start due to the following reasons:
1. No gasoline in the fuel tank or the fuel cock is closed. 2. The carburetor may be frozen or dirty. 3. Inappropriate compression in the cylinder (possibly due to worn or seized rings). 4. Lack of spark or poor spark timing. 5. Heavy load at low engine speed or high back pressure from a long exhaust pipe.
All three conditions—proper fuel-air mixture, appropriate compression, and good spark at the correct time—must be met for the engine to start.
This answer is automatically generated
Brad Boudreau
March 15, 2025
How do I attach spring and steel shaft onto carburetor?
1 comments:
Mr. Anderson
March 15, 2025
To attach the spring and steel shaft to the carburetor on a Robin EY15V:
1. Connect the throttle lever – Attach the carburetor throttle lever to the governor shaft using the connecting link. 2. Attach the governor spring – Connect the speed control lever to the governor lever using the governor spring, then mount it onto the fuel tank bracket. 3. Secure the choke lever – Connect the choke lever to the carburetor using the choke rod, then mount it onto the fuel tank bracket.
Ensure all connections are properly secured and positioned as required.
Need help?
Do you have a question about the EY15V and is the answer not in the manual?
Questions and answers
Hi not start
The Robin EY15V may not start due to the following reasons:
1. No gasoline in the fuel tank or the fuel cock is closed.
2. The carburetor may be frozen or dirty.
3. Inappropriate compression in the cylinder (possibly due to worn or seized rings).
4. Lack of spark or poor spark timing.
5. Heavy load at low engine speed or high back pressure from a long exhaust pipe.
All three conditions—proper fuel-air mixture, appropriate compression, and good spark at the correct time—must be met for the engine to start.
This answer is automatically generated
How do I attach spring and steel shaft onto carburetor?
To attach the spring and steel shaft to the carburetor on a Robin EY15V:
1. Connect the throttle lever – Attach the carburetor throttle lever to the governor shaft using the connecting link.
2. Attach the governor spring – Connect the speed control lever to the governor lever using the governor spring, then mount it onto the fuel tank bracket.
3. Secure the choke lever – Connect the choke lever to the carburetor using the choke rod, then mount it onto the fuel tank bracket.
Ensure all connections are properly secured and positioned as required.
This answer is automatically generated