Table of Contents
Advertisement
A07B500S manual
The screen cursor which displays the modulation will be still and the low left inscription RS232
Connection will show: not connected. At this point it is essential, after the transmitter has been
switched on, to make it communicate.
So the transmitter keyboard blue button marked as REMOTE 232 must be entered
The following page will appear on the display:
which indicates that by default the COM1 connection has been chosen instead of the COM3 and on
the COM2 no power amplifier is connected.
If on the COM2 an amplifier was connected automatically it would be detected and its caption
would appear beside the COM2 one.
If a modem connected to the telephone line is to be connected it needs to select by the horizontal
cursor and the data key the COM3.
If the selected options are right, pressing ENTER the communication to the PC connected to the
COM1 is entered, the blue key led switches on, on the display the cursor moves from left towards
right, displaying the modulation peaks as an oscilloscope and the caption connected will appear on
the left bottom.
The first page is just an introduction to the system, of which it' s possible to know the options
installed or the hour of the last switching on. At the right bottom of the display there is a grey
window with an arrow and if it is entered it' s possible to enter into the following pages:
Pag. 61
Advertisement
Table of Contents
