Safety Instructions; Introduction - T.E.M. A07B500S Manual

1.1

Introduction

T.E.M. has always managed to improve the safety standard if its transmitting and receiving
equipment. All produced systems are tested in compliance with international EN60950 and
EN60215 rules.
Obviously this is not sufficient to avoid any accident during the installation and the use of our
equipment in compliance with EN60215 rule, the radio transmitters and the auxiliary equipment
must be used by qualified technical staff only and T.E.M. declines any responsibility for damages
caused by an improper use or improper setting up performed by inexperienced staff, not qualified or
operating with instruments or tools not in compliance with safety set of rules.
CURRENT AND VOLTAGE WORKING IN THIS EQUIPMENT ARE
DANGEROUS. THE STAFF MUST ALWAYS OBSERVE THE SAFETY
RULES, INSTRUCTIONS AND NORMS CONTAINED HEREIN.
THE INSTRUCTIONS CONTAINED IN THIS MANUAL MUST BE READ
BEFORE SWITCHING ON OR SETTING THE TRANSMITTER
ANY TRANSMITTER SERVICING, REPAIRING OR CHECKING
OPERATION REQUIRING THE OPENING OF THE TOP OR BOTTOM
COVER, MUST BE PERFORMED AFTER THE MAINS SUPPLY
DISCONNECTION WITHOUT REMOVING THE EARTH CONNECTION
WHICH THE EFFICIENCY MUST BE VERIFIED: THE CABLE MUST BE
STAFF OPERATING UPON THE TRANSMITTER SYSTEM MUST NOT
BE TIRED: AFTER HEAVY WORKS OR CARRYING HEAVY
MACHINES BY HAND, IT IS NECESSARY TO RESPECT A PERIOD OF
REST BEFORE WORKING WITH SYSTEMS WHICH COULD HAVE
DANGEROUS ELECTRIC VOLTAGE IF THEY ARE NOT

SAFETY INSTRUCTIONS

WARNING
WARNING
WARNING
IN GOOD CONDITIONS AND WELL CONNECTED.
WARNING
DISCONNECTED.
Pag. 6
A07B500S manual