Remote Control - Pioneer VSX-D510 Service Manual

VSX-D510

Remote Control

MULTI CONTROL
DVD/LD TV/SAT VCR/DVR
1
RECEIVER TUNER
2
DSP MODE MIDNIGHT 5.1CH
1 2
CHANNEL TEST
SELECT TONE
3
5 6
CHANNEL
LEVEL
9 0
FUNC
4
TV CONTROL
VOL
ST
5
MENU
SOURCE CLASS
6
7
D.ACCESS
7
1 ¡
LOUDNESS FUNCTION MUTING
8
FL
9
RECEIVER
DIMMER
0
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
-
1 MULTI CONTROL buttons
Use to put the receiver/remote control in the stated mode.
For other equipment controls, see Controlling the Rest of
Your System.
2 RECEIVER button
Use this button when setting up the surround sound for
the receiver.
58
=
Î
CD
CD-R/
TV CONT
TAPE/MD
3 4
SIGNAL
ATT SELECT
7 8
EFFECT
~
‡
ENTER
10 DISC
CH
VOL
FQ
!
ST
ENTER
TOP
MENU
@
FQ
MPX BAND
8 3
#
CHANNEL
4 ¢
$
%
REMOTE
MASTER
SETUP VOLUME
^
3 NUMBER/MODE buttons
Use the number buttons to select the radio frequency in
tuner DIRECT ACCESS mode or the tracks in CD, DVD
mode etc.
Also, buttons marked with the following names have
special functions. If you try to use one of these functions
but the display flashes it means that function cannot be
used in the current mode (for example DSP modes
cannot be used when 5.1 CH setting is on).
Use to put receiver in DOLBY DIGITAL, DOLBY SUR-
ROUND and DTS modes. To use first press the
button then operate this button.
CEIVER
DSP mode
Use to put receiver in one of the DSP modes. To use first
press the button then operate this button.
RECEIVER
MIDNIGHT
Use to put receiver in MIDNIGHT mode. To use first press
the button then operate this button.
RECEIVER
5.1 ch
When the DVD/LD or DVD 5.1 CH function is selected
each press switches the DVD/LD input between DVD/LD
and DVD 5.1 CH. To use first press the
then operate this button.
CHANNEL SELECT
Use to select a speaker when setting up the surround
sound of the receiver. To use first press the
button then operate this button.
TEST TONE
Use to sound the TEST TONE when setting up the
surround sound of the receiver. To use first press the
button then operate this button.
RECEIVER
ATT
If the Overload indicator lights often, use to attenuate
(lower) the level of an analog input signal to prevent
distortion. To use, press the
press this button.
CHANNEL LEVEL +/–
Use to set up the levels of the surround sound of the
receiver. To use first press the
operate this button.
SIGNAL SELECT
Use to select the proper signal (analog, digital) for the
source your are inputting. To use first press the
button then operate this button.
4 THE FOLLOWING FOUR SETS OF BUTTONS ARE
DEDICATED TV CONTROL. THEY ARE ONLY USED
FOR CONTROLLING YOUR TV.
FUNC button
Use select the TV function.
TV POWER button
Use to turn on the power of the TV.
TV CHANNEL +/– buttons
Use to change channels on your TV.
TV VOLUME +/– buttons
Use to adjust the volume on your TV.
RE-
button
RECEIVER
RECEIVER
button first, then
RECEIVER
button then
RECEIVER
RECEIVER