Honda Civic Coupe 2000 Owner's Manual page 177

Cooling System
RESERVE
TANK
HOLDER
4. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
5. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
Maintenance
(U.S.: Si model, Canada: SiR
RESERVE
model)
TANK CAP
When the coolant stops draining,
apply non-hardening sealant to the
drain bolt threads, then reinstall
the bolt and tighten it securely.
6. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
With 5-speed manual transmission:
(U.S.: DX, EX and HX, Canada: DX
and Si)
0.82 US gal (3.1
(U.S.: Si, Canada: SiR)
1.14 US gal (4.3
With automatic transmission:
(U.S.: DX, Canada: DX)
0.79 US gal (3.0
(U.S.: HX, EX, Canada: Si)
0.85 US gal (3.2
7. Pour coolant into the radiator up
to the base of the filler neck. Start
the engine and let it run for about
,0.68 Imp gal)
30 seconds. Then turn off the
engine.
,0.95 Imp gal)
8. Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
,0.66 Imp gal)
9. Check the level in the radiator,
,0.70 Imp gal) add coolant if needed.
FILLER NECK
Fill up to here