Sony DVP-NS518P Operating Instructions Manual page 30

To output progressive signals
1
Select "PROGRESSIVE
(COMPONENT OUT ONLY)," and
press ENTER.
2
Select "ON," and press ENTER.
The display asks for confirmation.
3
Select "Start," and press ENTER.
The video switches to a progressive
signal for 5 seconds.
4
If the picture appears normal, select
"YES," and press ENTER.
If not, select "NO," and press ENTER.
To reset the setting
If the picture does not appear normal or goes
blank, press [/1 to turn off the player, and
enter "369" using the number buttons on the
remote, then press [/1 to turn on the player
again.
◆ MODE (PROGRESSIVE)
In order for these images to appear natural on
your screen when output in progressive
mode, the progressive video signal needs to
be converted to match the type of DVD
software that you are watching.
This setting is effective only when you set
"PROGRESSIVE (COMPONENT OUT
ONLY)" in "SCREEN SETUP" to "ON."
AUTO
Automatically detects the
software type (film-based or
video-based) and selects the
appropriate conversion mode.
Normally, select this position.
VIDEO Fixes the conversion mode to
the mode for video-based
software.
◆ 4:3 OUTPUT
This setting is effective only when you set
"TV TYPE" in "SCREEN SETUP" to
"16:9."
Adjust this to watch 4:3 aspect ratio
progressive signals. If you can change the
aspect ratio on your progressive format
(525p/625p) compatible TV, change the
setting on your TV, not the player. This
setting is effective only when
"PROGRESSIVE (COMPONENT OUT
ONLY)" is set to "ON" in "SCREEN
SETUP."
30
FULL Select this when you can
change the aspect ratio on your
TV.
NORMAL
Select this when you cannot
change the aspect ratio on your
TV. Shows a 16:9 aspect ratio
signal with black bands on left
and right sides of the image.
16:9 aspect ratio TV
For Taiwan model only
◆ BLACK LEVEL
Selects the black level (setup level) for the
video signals output from the jacks other than
COMPONENT VIDEO OUT.
ON
Sets the black level of the output
signal to the standard level.
OFF Lowers the standard black level.
Use this when the picture
becomes too white.
For Taiwan model only
◆ BLACK LEVEL (COMPONENT OUT)
Selects the black level (setup level) for the
video signals output from the COMPONENT
VIDEO OUT jacks. You cannot select this
when the player outputs progressive signals
(page 29).
OFF
Sets the black level of the output
signal to the standard level.
Normally, select this position.
ON Raises the standard black level.
Use this setting when the
picture appears too dark.