Oil Burner Technology - Omni OWR-150 Operation And Service Instructions Manual

Fuel Regulator
Fuel Filter
Fuel Pump
Figure 7 – Radiant Heater (Back View)
Omni's patented burner technology improves the efficiency of the oil burn process by continuous
stabilization of the oil viscosity. Optimum atomization (spray) is accomplished by precisely pre-
heating the oil and air prior to introduction to the combustion chamber. The waste oil enters into
the Oil Pre-Heater Block (figure 5) and is pre-heated to operating thermo setpoint, then
compressed air from the air compressor (figure 4) is mixed with the oil prior to spraying out the
nozzle similar to fuel injection, by breaking up the oil droplets into a finer mist or spray
(atomization). Electrodes mounted just above the nozzle (figure 6) provides continuous electrical
arc across electrode to electrode igniting the fine oil mist as it sprays out of the nozzle.
ignited the flame is forced into a swirl caused by the burners blower and specially designed flame
cone (figure 6) providing a very efficient and thorough burn of the waste oil.
Burner Components
•
Igniter Transformer: (figure 4) Supplies high voltage to the electrodes generating
electrical arc igniting the oil.
•
Oil Valve: (figure 6) energizes when burner is running and de-energizes when burner is
not running eliminating bleed back of oil out of the Pre-heater block.
•
Air Band: (figure 4) Adjusts amount of air introduced into the combustion chamber. Air
band is adjusted at the factory for optimum performance ½ to ¾ inch.
Operation and Service Instructions

OIL BURNER TECHNOLOGY

Once
NO FIELD
9