Door Swing; General Installation - U-Line 1000 Series Quick Start Manual

QUICK START GUIDE

Door Swing

Wall
1/4" Min.
(6 mm)
90°
Door Swing
Units have a zero clearance for the door to open 90°,
when installed adjacent to cabinets.
Stainless Steel and black and white models require 2-1/8"
(54 mm) door clearance to accommodate the handle if
installed next to a wall.
Integrated models require 1/4" (6 mm) clearance if
installed next to a wall. Allow for additional space for any
knobs or pulls installed on the integrated panel/frame.

General Installation

LEVELING INFORMATION
1. Use a level to
confirm the unit is
level. Level should
be placed along top
edge and side edge
as shown.
1
Wall
2-1/8" Min.
(54 mm)
90°
Door Swing
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary.
3. Confirm the unit is level after each adjustment and
repeat the previous steps until the unit is level.
INSTALLATION TIP
If the room floor is higher than the floor in the cut-out
opening, adjust the rear feet to achieve a total unit rear
height of 1/8" (3 mm) less than the opening's rear height.
Shorten the unit height in the front by adjusting the front
feet. This allows the unit to be gently tipped into the
opening. Readjust the front feet to level the unit after it is
correctly positioned in the opening.
PLACING THE UNIT INTO POSITION
1. Plug in the power cord.
2. Gently push the unit into position. Be careful not to
entangle the power cord.
3. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" (3 mm) below
the countertop.
4. Remove the tape from the glass shelves and wipe out
the inside of the unit with a clean, water-dampened
cloth.
4
u-line.com
Turn Foot to Adjust