Hughes JVC 335 Supplement To Service Manual page 14

5.2 Ignitor
IGNITOR
MOUNTING
BOARD
NEGATIVE
POSITIVE
IN
Model 335 Supplement
Figure 2. Ignitor Assembly.
The Ignitor Assembly consists of a Laser Power Supply, a High
Voltage Transformer and the associated wiring.
To remove the Ignitor Assembly:
1. Turn power off and unplug the projector.
2. Remove the front and rear covers.
3. Clearly label and remove the four (4) cables connected to the
Ignitor Assembly.
4. Remove the three (3) hex screws that attach the Ignitor
Mounting Board to the projector. NOTE: The larger washer
must be replaced to the hex screw at the left, front of the
Ignitor Mounting Board to allow space for the other component
that is connected there.
HEX SCREW
HIGH VOLTAGE
TRANSFORMER
LASER
POWER
SUPPLY
POSITIVE
OUT
14