Table of Contents
Advertisement
I
Preparation before convergence adjustment.
nstall a "convergence adjuster" in the following procedure before convergence adjustment.
I
1. Loosen 2 screws B of convergence adjuster. (Figure-1)
2. Put a convergence adjuster on a prism unit, insert 2 screws A and tighten it a bit. (Figure-1)
3. Loosen 2 screws D. (Figure-3 and 4)
gence adjuster can connect easily.
4. Slide a convergence adjuster in the direction of arrow-C and insert a convergence adjuster in a LCD
panel unit. (Figure-2 and 4.)
5. Tighten 2 screws A and 2 screws B. Preparation of convergence adjustment was completed.
To remove the adjuster, take reversed in the above.
SCREW-A
SCREW-B
C
SCREW-B
SCREW-A
C
I LCD Panel convergence adjustment.
And move the LCD panel to the position which the conver-
GUIDE
Fig.-1
Fig.-2
Optional convergence adjustment tool (Refer to page-44)
INSERT
ZOOM IN
-46-
" Convergence Adjuster "
F
E
Fig.-3
Screw-D
Screw-D
Fig.-4
G
Screw-D
Advertisement
Table of Contents
