Table of Contents
Advertisement
Self Charging Battery Back-up
The special NiCad 2.4v self-charging battery recharges continuously during train
operation and should last for up to five years. The battery is a dry battery that
should not leak or cause any damage to your engine. Depending upon when your
engine was built, it may need to be charged right out of the box. If engine sounds
seem distorted or garbled at low voltages or become silent when power from the
transformer is turned off, test the battery to determine whether it should be
recharged or replaced.
Test: Put the engine in neutral and
leave the track voltage at 10-12 volts
(high enough for the lights to shine
brightly) for 15 minutes.
Recharge: If the sounds are improved
at the end of the 15-minute test charge,
the battery charge has run down and can
be recharged. There are a number of
ways you can do this:
• Leave the engine in neutral with track voltage at 10-12 volts
for 6-7 hours so the battery can fully recharge (if your engine has a
smoke unit, be sure it is turned off).
•Use M.T.H.'s battery recharger (sold separately) that plugs into a wall
outlet and a special port under the engine to recharge the battery
overnight without leaving it on the track.
Replace: If the sounds are not improved at the end of the 15-minute test charge,
it is time to replace the battery. Available through M.T.H. Parts.
Disconnect Battery And Slide Out Of Bracket
Figure 8. Battery Location.
Tinplate IVES 3243 R Electric Locomotive
Battery Charger Port
Figure 7. Battery Charger Port location.
12
Advertisement
Table of Contents
