Kenwood TK-880 Service Manual page 8

Status Entry (5-tone)
It allows the operator to input the status and transmit it to
the base station.
Both TX address and "Selectable status digit" must be
programmed to perform the operation. Press [Status entry]
key to access Status entry mode. "TX address" of the chan-
nel appears on LCD.
Enter the desired code using a numeric keypad. If the
transceiver does not have the numeric keypad, you can use
[Channel up]/[Channel down] key to select the desired num-
ber and press [C] key to enter. The cursor moves to next
position.
Status List (5-tone)
Press [Status list] key to enter Status list mode. Select
the check box of "5-tone - System parameters - Selectable
status digit". The number of digit you selected in "5-tone -
Status list" will be displayed on LCD. If "Status list" has not
been programmed, same digits of status list code that you
checked as "Selectable status" digits will appear on LCD.
To select the status list, use [Channel up]/[Channel
down] key or [2]/[8] key on the microphone keypad.
Talk Around
When Talk around function is activated, "TA" appears and
the transceiver transmits on the receive frequency, using
receiver's QT/DQT code.
The operator can call the other party directly (without re-
peater).
Transfer (5-tone)
When you select "5-tone" for "Signalling type for decode",
this function is used for transmitting 5-tone code. Press the
[Transfer] key to activate the transfer function. "TRANSFER"
appears on the LCD.
When the target 5-tone code is received, you can select
to transfer the code to another transceiver. When a mobile
transceiver receivers the target 5-tone code, a mobile trans-
ceiver transfers the received 5-tone code to a portable.
When "Special setting" is selected (enabled) and using
decode format, this parameter is not valid.
None
When you press this key, the transceiver emits the "Key
input error tone" (no function is performed).
Volume Up/Down
When this key is pressed, the volume level is increased/
decreased and repeats if held for 200ms or longer.
OPERATING FEATURES
None
Auto dial
Auto dial programming
AUX A
AUX B
Note : Only when voice scrambler is not selected.
Call 1
Call 2
Call 3
Call 4
Call 5
Call 6
Channel down
Channel entry
Channel name
Channel up
Emergency call
Fixed volume
Group down
Group up
Home channel
Horn alert
Key lock
Monitor
Monitor momentary
Operator selectable tone
Public address
Queue
Radio password
Receive entry
Scan
Scan delete/add
Scrambler
Selcall entry
Selcall list
Selcall + Status entry
Selcall + Status list
Send GPS
Shift
Squelch level
Squelch momentary
Squelch off
Status entry
Status list
Talk around
Transfer
Volume down
Volume up
Function Table
Function DTMF/2-tone/DMS
TK-880
5-tone
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
No Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
7