JVC RX-DV3SL Service Manual page 12

RX-DV3SL
Removing the the top cover
Prior to performing the following procedures, remove
the DVD / CD tray.
1.
Remove the four screws marked A attaching the top
cover on the DVD / CD unit.
2.
Pull the top cover toward the direction of the arrow
and draw the top cover toward the upper side.
Removing the tray drive motor board
Prior to performing the following procedures, remove
the DVD / CD tray, top cover, servo board and DVD /
CD unit.
1. Unsolder the solder points at the tray drive motor
board.
2. Detach the belt from the pulley on the bottom of the
DVD / CD unit. (Do not stain the belt with grease).
3. Remove the screws marked B attaching the tray
drive motor on the DVD / CD unit.
4. Remove the screws marked C attaching the tray
drive motor board on the DVD / CD unit.
1-12
(See Fig.4)
Pulley
(See Fig.5, 6)
Belt
B
Motor
Solder
points
Motor
A
Top cover
A
Fig.4
Fig.5
Tray drive
motor board
C
Fig.6
DVD / CD
A
unit
Stopper
Stopper
A
DVD / CD
unit
DVD / CD
unit