JVC RX-DV3SL Service Manual page 11

<DVD / CD unit>
Prior to performing the following procedures, remove
the DVD / CD unit.
Removing the DVD / CD tray
1. Push the cam lever toward the center side of the
DVD / CD unit in the direction of the arrow and draw
the DVD / CD tray toward the front.
2. Push the two tray stoppers marked a on the DVD /
CD tray in the direction of the arrow and draw the
DVD / CD tray toward the front.
Reinstall the DVD / CD tray
1. Align the rail with the DVD / CD tray as shown fig.2,
then mount the DVD / CD tray.
Removing the DVD / CD servo board
1. Disconnect the card wire from the connectors
CN101, CN201 and CN202 on the DVD / CD servo
board.
2. Push the two DVD / CD servo board hooks marked b
and pull out the DVD / CD servo board.
(See Fig.1, 2)
(See Fig. 1, 2)
(See Fig.3)
CN201
Hook b
DVD / CD
servo board
Loading cam lever
Fig.1
a (Tray stopper)
Fig.2
DVD / CD
Fig.3
RX-DV3SL
DVD / CD
tray
tray
Loading
cam
lever
Hook b
CN202
CN101
1-11