General Operating Instructions - Galaxy G8 Installation And Operation Instructions Manual

GENERAL OPERATING INSTRUCTIONS

The motor air exhaust holes located on top of the machine must be clear of any obstructions.
DO NOT COVER THESE AIR VENT HOLES AS SERIOUS DAMAGE WILL RESULT.
Make sure the corn drawer is in place on the machine before starting the popping
cycle.
. Turn on both switches.
2. For the first batch allow kettle to preheat for 5-7 minutes. No preheat is required after first batch
is popped.
3. Add popping oil to kettle. Immediately add popcorn and seasoning salt and close kettle lid. For
best results, ratio is  part of oil to 4 parts of corn. Use measuring cups provided or proportioned
corn/oil packages. Contact your local Dealer for pre-portioned packages.
4. Immediately empty kettle when popping stops.
5. Repeat step 3 immediately or turn kettle off.
IMPORTANT
Turn kettle heat switch off when not popping!
Never pop corn without oil!
SWITCHES
The corn freshener and heat lamp switch controls the
bottom heating element and the top heat lamp. The
kettle heat switch controls the kettle heating element
& the corn agitator. This motor should be kept running
when there is corn in the kettle to prevent scorching or
burning.
KETTLE
The kettle heating element is thermostatically controlled.
Thermostat adjustment should not be necessary since it has
been preset at the factory for the correct popping temperature.
Dump the kettle by turning the kettle handle counterclockwise
90° to release its latch and hold the handle in this position
while tipping the kettle and handle down (see Figure ).
Do not leave the kettle heat & corn agitator switch "ON" () when the machine is not in use.
Do not immerse the kettle in water or allow water to come in contact with the heating
element.
Popping corn without oil in the kettle (a dry kettle) is not recommended.
Do not connect the machine to direct current (DC) since it is designed to operate on alternating
current (AC) only.
CAUTION
CAUTION
6
All of the above switches are in the ON
position when they are lighted.
IL1031A