General Installation Data - Galaxy G8 Installation And Operation Instructions Manual

GENERAL INSTALLATION DATA

CAUTION
This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by the
general public in food service locations.
Before using your new equipment, read and understand all the instructions & labels associated with
the unit prior to putting it into operation. Make sure all people associated with its use understand the
units operation & safety before they use the unit.
All shipping containers should be checked for freight damage both visible and concealed. This
unit has been tested and carefully packaged to insure delivery of your unit in perfect condition. If
equipment is received in damaged condition, either apparent or concealed, a claim must be made
with the delivering carrier.
Concealed damage or loss - if damage or loss is not apparent until after equipment is
unpacked, a request for inspection of concealed damage must be made with carrier within
5 days. Be certain to retain all contents plus external and internal packaging materials for
inspection. The carrier will make an inspection and will supply necessary claim forms.
INSTALLATION
Each machine has been properly wired and inspected at the factory for operation on the voltage and
type of current specified on the nameplate.
CAUTION
DO NOT CONNECT TO ANY OTHER TYPE OF CURRENT OR THE MACHINE WILL
BE SERIOUSLY DAMAGED.
A receptacle is furnished with the G2 20 volt and G4 20 volt popcorn machines.
We strongly recommend installation by a licensed electrician. The guarantee of this machine as
covered by the warranty does not apply if an improper installation has been made.
120 VOLT MACHINES
Machines with a nameplate stamped 20V, are equipped for operation on 20 volt 60 hertz AC single
phase service and must be connected to a separate 20 amp circuit with a 3 wire grounded, polarized
receptacle. NOTE: The G4 20V machine uses a 30 amp circuit.
240/230 VOLT MACHINES
Machines with a nameplate stamped 240V, are equipped for operation on 240 volt 50/60 hertz AC
single phase service. Machines with a nameplate stamped 230V, are equipped for operation on 230
volt 50 hertz AC single phase service. All must be connected to a separate 5 amp circuit with a 3
wire grounded, polarized receptacle.
5