Advertisement
AN3012DAB Installation Guide
fiber; also peel off a small portion of the adhesive separator on the Copper
Strip. Then, press and bond the Signal Booster to the marked location
from pre-installation and on the inside of the front windshield. Ensure that
the Signal Booster, Copper Strip, and Antenna are not distorted.
➋
Attach the Copper Strip
Gently peel off the rest of adhesive separator of the Copper Strip and
paste it across the windshield to the metal frame of the A Pillar, press and
smooth out the Copper Strip. Secure the Copper Strip, with the supplied
3M tape, on to the metal windshield frame.
➌
Attach the Antenna
Gently peel off the rest of adhesive separator of the Antenna and paste it
on the inside of the front windshield. While pressing and smooth out
the Antenna to the glass, take precaution that you do not over press
the joint, between the Antenna and the Signal Booster.
➍
Secure the Coaxial Cable
Secure the coaxial cable tightly against windshield, then tightly against
and diagonally across to the metal frame of the A-Pillar with the supplied
3M tapes. Securing the coaxial cable this way avoids the A pillar
damaging the antenna cable and affecting performance.
➎
Secure Junction Box
Secure the Junction Box with the supplied 3M tape on the metal frame.
➏
Secure the Antenna Cable
Secure the antenna cable tightly down on the metal frame of the A-Pillar
with the supplied 3M tape.
Re-attach A Pillar cover
Re-attach the A Pillar cover, with the antenna cable runs out of bottom of the
cover.
Route the antenna cable
Route the antenna cable from the bottom of the A-Pillar cover within the car
interior to the DAB receiver, make sure the antenna cable does not interfere
with the safe operation of steering wheel, air bags, and seatbelts or other
equipment.
Connect to the DAB receiver
a. Power off the DAB receiver.
b. Plug the Antenna Connector at the end of the antenna cable into DAB
receiver's antenna input connector.
c. Power on the DAB receiver and start using your DAB receiver with the
DAB antenna.
Note:
To achieve the best performance, Antenna must not be placed over a UV
protection layer.
-5-
Advertisement
