Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for DABmotion AN3012DAB
- Page 1 AN3012DAB Glass-Mount DAB Antenna Installation Guide...
-
Page 2: Table Of Contents
AN3012DAB Installation Guide Table of Content INTRODUCTION ........................1 OVERVIEW .......................... 1 ANTENNA INSTALLATION ....................2 Pre-installation ....................2 Permanent Installation ..................4 SPECIFICATION ........................6... -
Page 3: Introduction
This DAB antenna can be installed on either side of the front windshield only. The vehicle’s DAB receiver must provide a 12V phantom power to the SMB connector for the DAB antenna (standard when used with DABmotion). Once the DAB antenna is adhered to the windshield it can not be relocated. -
Page 4: Antenna Installation
AN3012DAB Installation Guide ANTENNA INSTALLATION The AN3012DAB antenna can be installed on either side of the front windshield by rotating the DAB antenna and flipping the antenna cable around: Left Mount Right Mount 1. Pre-installation The glass-mount antenna must be placed on the top corner and on the either side of the front windshield. - Page 5 AN3012DAB Installation Guide Left Mount A Pillar UV Protection Layer 5 cm 1.3 A Pillar and Windshield The windshield usually has a black enamel band along the edges that contains a border of dots and a black-shade area, the Signal Booster is to be installed next to the dotted area along the side of the windshield.
-
Page 6: Permanent Installation
AN3012DAB Installation Guide Permanent Installation You should complete reviewing the pre-installation section and fit the antenna before you begin the permanent installation of this DAB antenna. 2.1 Clean the windshield Ensure the chosen antenna location on the windshield is clean and free of dirt, water, and other substance which will help the antenna adhere to your car windshield properly. - Page 7 AN3012DAB Installation Guide fiber; also peel off a small portion of the adhesive separator on the Copper Strip. Then, press and bond the Signal Booster to the marked location from pre-installation and on the inside of the front windshield. Ensure that the Signal Booster, Copper Strip, and Antenna are not distorted.
-
Page 8: Specification
SPECIFICATION L-Band: 1450 - 1490 MHz Frequency Range Band III: 170 - 250 MHz L-Band: < 1.42 : 1 VSWR Band III: < 1.98 : 1 L-Band: > 30.6 dBi Amplification Band III: > 21 dBi Signal-to-Noise 1.18 dB Ratio DC Voltage +12 V DC Current Input...
Need help?
Do you have a question about the AN3012DAB and is the answer not in the manual?
Questions and answers