Table of Contents
Advertisement
No.
Adjusting point
31
Checking and
1.The adjustment condition of
readjustment of
white balance
2. A digital television does
32
Colour system
1. Receive the colour bar sig-
performance
check
33
Video system
1. Receive the monoscope
performance
check
34
Audio system
performance
check
35
RGB
1. Receive the RGB signal.
performance
check
36
Off-timer
performance
check
37
Thermistor
1. Heat the thermistor using a
performance
check
38
Automatic
1. Receive the PHASE check
synchronization
39
Keystone
correction
performance
check
40
Factory settings
Adjusting conditions
each item is as mentioned
in the following.
RGB input:Refer to No.13
VIDEO input:Refer to No.23
DVD input:Refer to No.28
compensation adjustment
by using "CR-OFFSET" or
"CB-OFFSET".
nal.
pattern signal.
dryer.
pattern signal.
31
Adjusting procedure
» Make sure that a white balance is the best condi-
tion.
» Make this adjustment after finishing the above ad-
justment.
» In the process mode and select L1. Check the col-
our and tint.
» In the process mode and select L2. Check the pic-
ture, brightness and sharpness.
» In the process mode nad select L3. Check the bass,
treble and balance.
» In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
» In the process mode and select OFF. Make sure that
the off-timer starts with "5" (minutes), counts down
each minute in 1 second, and turns off the set at "0".
» Make sure the "TEMP" is displayed.
» Call the VGA/S-VGA/XGA mode and make sure
that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
» Make sure the keystone correction functions well.
» Make the following settings.
Process
Remote controller
adjustment
setting
S3
"Factory setting 3"
XG-P10XE
Advertisement
Table of Contents
