Section I - Electric Compactors
1) Remove PIG
Waste Compactor from pallet and place on floor.
®
2) If desired, permanently mount the compactor to the floor using the pre-drilled holes in the
base. Up to 1/2" floor anchors can be used. Floor anchoring not required for operation
(anchors not included).
3) Power source required: 120 Volt AC with 15 amp breaker.
4) Wire unit to terminal block inside closure through hole marked 120 Volt AC 15 amp as
shown in schematic. (Note: wiring should be performed by a qualified electrician)
4
1 Setup Instructions