Timer Recording - Panasonic NV-VP33EB Operating Instruction

Timer recording

Timer recording
Pos Date Start Stop
1 BBC1 31/12 10:30 11:30 SP ON
2 BBC2 31/12 11:30 12:30 SP ON
3 ITV 31/12 12:30 13:30 SP ON
4 CH4 31/12 13:30 14:30 SP ON
5 CH5 31/12 14:30 15:30 SP ON
-- - - - - - -/ - - - -: - - - -:- - SP - - -
:select : store
ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER ENTER
: delete : exit
CANCEL EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT EXIT
28
The Timer recording allows you to programme the recording time of TV
programmes up to 1 month in advance. Use the on-screen menu to programme
a maximum of 16 recordings. Do not forget to verify that there is enough tape
left. The length of the recording must not exceed the tape left on the video
cassette.
PROG/CHECK
1 / 3
Press MENU, and confirm
PDC
or press PROG/CHECK to display the Timer recording menu.
Press ENTER to access timer programming.
Select a station
Press
Press
Hold buttons down to change time in 30-minute steps.
Press
Press
Press ENTER to save timer programme.
Repeat these steps for further recordings you may wish to programme.
Press TIMER to activate the VCR´s timer mode.
Make sure the symbol
button on the device also lights up if the function was not turned off.
The Timer Rec button blinks for 5 seconds if the timer is turned on and you try
to perform a function. Most buttons are blocked when the timer is turned on.
Do not forget to verify that there is enough tape left. The length of the
recording must not exceed the tape left on the video cassette.
To cancel the Timer recording Standby Mode
When you want to use the VCR for playback or manual recording before the
programmed timer recording will be performed, you can temporarily cancel the
timer recording standby mode.
Press TIMER button. The
However, after you have finished using the VCR, remember to reactivate the
timer recording standby mode.
Press TIMER button again, otherwise the programmed timer recording will
not take place.
Timer recording with ENTER
(e.g. BBC1).
to set date, week or weekday with
to set start- and stop-time with
to select tape speed: A (Automatic), SP, LP, EP with
to set PDC ON/OFF with
is displayed on the VCR display.
indication on the VCR display disappears.
(e.g. 31/12).
, (e.g. 10:30).
.
The Timer Rec
.