Connection Diagram; Схема Подсоединения - Sony CDX-GT610U Service Manual

* 2
SUB OUT (MONO)
* 1
from car antenna (aerial)
2
AMP REM
Max. supply current 0.3 A
ATT
Note for the antenna (aerial) connecting
* 1
If your car antenna (aerial) is an ISO
(International Organization for Standardization)
type, use the supplied adaptor 2 to connect
it. First connect the car antenna (aerial) to the
supplied adaptor, then connect it to the antenna
(aerial) jack of the master unit.
* RCA pin cord (not supplied)
2
* 3 Be sure to match the color-coded cord for
audio to the appropriate jacks from the unit. If
you connect an optional CD/MD changer, you
cannot use AUX IN terminal.
* 4 Supplied with the auxiliary equipment
* 5 Insert with the cord upwards
* 6 Supplied with XA-C40

Connection diagram

A To AMP REMOTE IN of an optional power
amplifi er
This connection is only for amplifi ers. Connecting any other
system may damage the unit.
B To the interface cable of a car telephone
Warning
If you have a power antenna (aerial) without a relay box,
connecting this unit with the supplied power supply lead
3 may damage the antenna (aerial).
Notes on the control and power supply leads
• The power antenna (aerial) control lead (blue) supplies +12 V
DC when you turn on the tuner, or when you activate the AF
(Alternative Frequency) or TA (Traffi c Announcement) function.
• When your car has built-in FM/MW/LW antenna (aerial) in the
rear/side glass, connect the power antenna (aerial) control
lead (blue) or the accessory power input lead (red) to the
power terminal of the existing antenna (aerial) booster. For
details, consult your dealer.
• A power antenna (aerial) without a relay box cannot be used
with this unit.
Memory hold connection
When the yellow power input lead is connected, power will
always be supplied to the memory circuit even when the ignition
switch is turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms, and with
adequate power handling capacities to avoid its damage.
• Do not connect the speaker terminals to the car chassis, or
connect the terminals of the right speakers with those of the
left speaker.
• Do not connect the ground (earth) lead of this unit to the
negative (–) terminal of the speaker.
• Do not attempt to connect the speakers in parallel.
• Connect only passive speakers. Connecting active speakers
(with built-in amplifi ers) to the speaker terminals may damage
the unit.
• To avoid a malfunction, do not use the built-in speaker leads
installed in your car if the unit shares a common negative (–)
lead for the right and left speakers.
• Do not connect the unit's speaker leads to each other.
Note on connection
If speaker and amplifi er are not connected correctly, "FAILURE"
appears in the display. In this case, make sure the speaker and
amplifi er are connected correctly.
Auxiliary equipment such as portable DVD
player (not supplied)
*
2
*
2
BUS AUDIO IN/
3 AUDIO OUT
*
AUX IN
FRONT
L
R
BUS AUDIO AUDIO
AUDIO OUT OUT
IN REAR FRONT
Fuse (10 A)
AUDIO OUT
REAR
3
Blue/white striped
Light blue
* 1
* 2
* 3
* 4
* 5
* 6
See "Power connection diagram" on the reverse
side for details.
CDX-GT610U/GT616U/GT617UE
* 4
Source selector
(not supplied)
XA-C40
REMOTE
IN
*
6
*
5
BUS
CONTROL IN
from the car's speaker
connector
Speaker, Rear, Right
1 +
Purple
Speaker, Rear, Right
2 –
Speaker, Front, Right
3 +
Grey
Speaker, Front, Right
4 –
Negative polarity positions 2, 4, 6, and 8 have striped leads.
from the car's power connector
Yellow continuous power supply
4
Blue power antenna (aerial) control
5
Orange/White switched illumination power supply
6
* 5
1 3 5 7
2 4 6 8
Speaker, Front, Left
5 +
White
Speaker, Front, Left
6 –
Speaker, Rear, Left
7 +
Green
Speaker, Rear, Left
8 –
5 7
4 6 8
Red switched power supply
7
Black ground (earth)
8
9