Table of Contents
Advertisement
10.3. HD panel white balance
INPUT
Equipment
PC
1
(HD:720i or 1080i) Color
Gray Scale
Analyzer
Pattern
High light 75%
Low light 15%
2
3
4
Setting
Alignment menu
Picture:
Normal Sub Adjust
White balance:
Sub Bright 2) Adjust Sub bright to set Low light level to 10 cd/m
Cool
Aspect:
PANEL W/B
16:9
G cut off 3) Set G cut off to " 80 ".
PANEL W/B
Component /RGB-in
B cut off 4) Adjust B and R cut off to set color temperature as
Component
R cut off
Sub Adjust
Sub Bright 5) If Sub Bright is changed re-adjust it to set Low light
PANEL W/B
G Drive 7) Set G Drive to " E8 ".
PANEL W/B
R Drive
PANEL W/B
All Drive 10) Set All Drive to "FC".
PANEL W/B
R,G,B cut off 11) Re-adjust Low light level again.
Picture:
Normal PANEL W/B
White balance:
R,G,B cut off 2) Repeat procedure 3) to 11) of Cool mode.
Normal PANEL W/B
Aspect:
R,G,B Drive
16:9
Picture:
Normal PANEL W/B
White balance:
R,G,B cut off 2) Repeat procedure 3) to 11) of Cool mode.
Warm PANEL W/B
Aspect:
R,G,B Drive
16:9
Picture:
Picture Menu
Normal Sub Adjust
White balance:
Sub Bright 2)Re-set Sub bright to "30"
Cool
Aspect:
16:9
1) Find the nearest area to brightness of 10 cd/m
light by color sensor.
exactly.
shown Fig.-04.
to 10 cd/m
.
2
6)Find 75% of white area by color sensor.
B Drive 8) Adjust B and R Drive to set color temperature
as shown Fig.-04.
9) Repeat item 4) to 7) to set both Low light and
high light.
Color Temp.
Cool(Hi)
Normal(Mid)
Warm(Low)
1) Change white balance to "Normal".
1) Change white balance to "Warm".
1) Change color templature to "Cool".
– 19 –
Procedure
as Low
2
x
y
0.276
0.276
0.288
0.296
0.313
0.329
Fig. -04
50XP37
2
Advertisement
Table of Contents
