Sony HVR-Z7E Operating Manual page 165

AC adaptor/charger
Do not short-circuit the DC plug of the AC adaptor/charger
or battery terminal with any metallic objects. This may cause
a malfunction.
To install the battery pack to this unit
Slide the battery pack in the direction of the b mark on
the battery pack.
To remove the battery pack from this unit
Press the BATT RELEASE button of this unit and slide the
battery pack in the direction of the arrow.
To connect this unit to a wall outlet
For prolonged operation, such as playing the recorded
images, you can operate this unit from a domestic wall outlet
without worrying about battery life.
1
Set the mode change switch of the AC adaptor/
charger to VCR/CAMERA.
Notes
When the mode change switch is set to CHARGE, there is
no power supply.
2
Connect the DK cable to the DC IN jack on this unit.
3
Connect the DK cable to the AC adaptor/charger.
4
With the power cord, connect the AC adaptor/charger
to a wall outlet.
Notes
You can leave the battery pack installed while operating from
AC power. The power supply to the DC IN jack has priority.
To use the AC adaptor/charger from a vehicle
power supply
For details, refer to the operating instructions supplied with
the AC adaptor/charger.
Notes on battery pack/AC adaptor
• Avoid the following while the ACCESS lamp is lit. Failure
to do so may cause malfunction.
– Removing the battery pack
– Removing the AC adaptor (while charging with the AC
adaptor)
• Always turn off the POWER switch before removing the
battery pack or the AC adaptor.
21