Octopus 44364 Installation Manual page 9

www.octopusdrives.com
www.octopuseurope.com
• Remove steering link arm
i) To simplify the re-assembly proce-
dure, make a note of the connections
between the steering link arm and the
manual steering cable and engine tiller.
ii) Disconnect the steering link arm from
the manual steering cable and the
engine tiller.
iii) Retain the link arm and fixings etc for
later use.
• Fit the secondary steering cable mount bracket to the engine tilt bracket
i) The bracket attaches to the four threaded mounting holes on the front face
of the tilt tube (Fig B6). Four M6/
supplied in the kit.
ii) Torque the bolts to 100in-lb (11Nm).
Primary
steering cable
Mount bracket
Subject to change without notice
⁄ in-28 UNF bolts and lockwashers are
1
4
Fig B6 - Fitting the cable mount bracket
9 of 44
Steering
link arm
Fig B5 - Removing steering link arm
OC15269 REV F