Octopus 44364 Installation Manual page 19

www.octopusdrives.com
www.octopuseurope.com
v) Use the manual helm to set the steering to the midstroke position. Adjust the
position of the drive collar so that there is a 7.3in (185mm) gap between it
and the front face of the steering cylinder (Fig B23). Tighten the drive collar
clamp screw and torque to 175in-lb (19Nm). Tighten the drive collar lock nut
and torque to 45in-lb (5nm).
* This diagram shows the earlier model Volvo cylinders, which featured a "necked" guide tube -
later models have a simpler parallel guide tube, which does not require the use of the Drive Collar
Spacer Bush .
• Refer to section B9 on connecting the secondary steering cable to the drive unit.
Subject to change without notice
when steering is centered
Guide Tube*
Fig B23 - Positioning the drive collar
19 of 44
7 .3in (185mm)
OC15269 REV F