www.octopusdrives.com
www.octopuseurope.com
v) Use the manual helm to set the steering to the midstroke position. Adjust the
position of the drive collar so that there is a 7.4in (188mm) gap between it
and the front face of the steering cylinder (Fig B17). Tighten the drive collar
clamp screw and torque to 175in-lb (19Nm). Tighten the drive collar lock nut
and torque to 45in-lb (5nm).
• Refer to section B9 on connecting the steering cable to the drive unit
Subject to change without notice
7 .4in (188mm)
when steering is centered
Fig B17 - Positioning the drive collar
15 of 44
OC15269 REV F