Table of Contents
Advertisement
● Code : 07-002
53-005
● Symptom : Exit motor has stopped for printing job.
● Possible Cause: Exit sensor defect , Exit motor defect ,Finisher main board defect.
● Troubleshooting method :
1. Check if the Finisher cable is connected to the
machine.
2. Open the finisher bottom cover and check the LED
on the finisher main board.
At that time, all finisher doors must be closed.
Check if the red, yellow, green LED are on.
3. If the yellow LED is not on, check the connection of
the switch in the Finisher Front Door.
Troubleshooting
● Error message : Paper jam at exit of finisher
4. Check if the finisher exit sensor harness is connected
properly or actuator is broken.
5. Check if the finisher exit motor harness is connected or
operated properly.
6. If the problem persists, replace the finisher main board.
4-115
Advertisement
Table of Contents
Troubleshooting
