Firmware Renewal Mode - FUNAI LD195SSX Service Manual

< DVD Section >
1. Turn the power on and press [EJECT] button on
the remote control unit to put the LCD TV/DVD into
DVD mode. Then remove the disc.
2. To put the LCD TV/DVD into F/W version up mode,
press [9], [8], [7], [6], and [MODE] buttons on the
remote control unit in that order.
Fig. a appears on the screen.
" ******* " differs depending on the models.
F/W Version Up Mode
Please insert a DISC
for F/W Version Up.
Fig. a Version Up Mode Screen
3. Insert the disc for version up into the disc slot.
4. The LCD TV/DVD enters the F/W version up mode
automatically. Fig. b appears on the screen. Make
sure to insert the proper F/W for the state of this
model.
" ******* " differ depending on the models.
F/W Version Up Mode
VERSION :
Reading...
(*1)
Fig. b Programing Mode Screen
The appearance shown in (*1) of Fig. b is
described as follows:
No. Appearance
1 Reading... Sending files into the memory
2 Erasing... Erasing previous version data
3 Programming... Writing new version data

FIRMWARE RENEWAL MODE

Model No : ******
VERSION : *.**
EXIT: SELECT
Model No : ******
VERSION : *.**
************.***
State
5. After programming is finished, the disc will be
ejected automatically. Fig. c appears on the
screen and the checksum will be shown in (*2).
" ******* " differ depending on the models.
F/W Version Up Mode
VERSION :
Completed
SUM : ****
(*2)
Fig. c Completed Program Mode Screen
At this time, no button is available.
6. Remove the disc.
7. Unplug the AC cord from the AC outlet. Then plug
it again.
8. Press [EJECT] button on the remote control unit to
put the LCD TV/DVD into DVD mode again.
9. Press [1], [2], [3], [4], and [INFO] buttons on the
remote control unit in that order.
Fig. d appears on the screen.
" ******* " differs depending on the models.
MODEL : ******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR
10. Press [CLEAR] button on the remote control unit.
Fig. e appears on the screen.
" ******* " differs depending on the models.
MODEL : ******
Version : *.**
Region : *
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR
When "OK" appears on the screen, the factory
default will be set. Then the firmware renewal
mode is complete.
11. To exit this mode, press [CHANNEL UP/DOWN]
button to go to TV mode, or press [POWER] button
to turn the power off.
8-1
Model No : ******
VERSION : *.**
************.***
EXIT: SELECT
Fig. d
EXIT: SELECT
Fig. e
A94N1FW