Qls 21M62US (CHASSIS: NX56-LA) Service Manual page 26

TCL-THOMSON Electronics R&D Center (Shen'Zhen Lab)
RPA 1
RPO 1
SOC 2
PWL 8
COR 0
5. Enter P-Mode, press key "8" to select page "8". Set the corresponding item to require
value. See below table 3.6.5 for detailed description.
Table 3.6.5: Producing parameter setup and option page "8"
OSD menu
HOTEL
BTSC
SAP
BTSC AUTO
AV ALIGMENT
AV2 ENABLE
SHVS ENABLE
YUV ENABLE
NO COMMAND ENABLE
LANGUAGE PORTUGA
LANGUAGE SPAISH
AVOUT Follow
Chassis Name
Issued on
Updated on
Ratio pre- and aftershoot
0-1:1, 1-1.5:1, 2-2:1
Ratio of positive and negative peaks
0-1:1 1-1:1.3,
Vottage difference between soft clipping and pwl
0 -0% above pwl level
2-10% above pwl level
Peak White Limiting
Video dependtent coring(peaking)
0-off 1-coring active 0 and 20IRE
2-coring active 0 and 40IRE
3-coring active 0 and 100IRE
Default Value
0
1
0
2
1
1
1
1
0
1
1
0
NX56-LA
2008-05-19
2010-01-27
2-1:1.7, 3-1:0.7
1-5% above pwl level
3- soft pwl
Description
HOTEL MODE
1: open 0:close
BTSC's option
1: open 0:close
SAP 's option
1: open 0:close
BTSC AUTO Select
2: AUTO 0:Manual
AV terminal align
AV2 terminal enable
S-Video terminal enable
YUV terminal enable
No operation within 2 hours
automatic standby enable
Avout follow signal change
1=follow 0=only tv
Serial No.
Page
Version
Don't adjust, use default
Don't adjust, use default
Don't adjust, use default
Adjust to right value accord
with the tube.
Recommended value= "8"
Don't adjust, use default
Remark
according to
ODF
according to
ODF
When BTSC ON
advice SET 1
Recommended
value= 2
0=3 x 3
1=4 x 3
0=Disable
1=Enable
Recommended
value= 1
Page 14 of 15
2.2