Qls 21M62US (CHASSIS: NX56-LA) Service Manual page 24

TCL-THOMSON Electronics R&D Center (Shen'Zhen Lab)
C. C olour curve:
OSD menu Default Value
COL0 0
COL50 32
COL100 50
D. Volume curve:
OSD menu Default Value
VOL0 0
VOL10 38
VOL10 65
VOL50 71
VOL80 77
VOL100 81
2. Enter P-Mode, press key "5" to select page "5". Set the corresponding item to require
value. See below table 3.6.2 for detailed description.
Table 3.6.2: Producing parameter setup and option page "5"
OSD menu Default Value
Track. Mode
VX Normal
VX Compr.
HBL
WBF
WBR
GET OFFSET
ColdRD
ColdGD
ColdRC
ColdGC
WarmRD
WarmGD
WarmRC
WarmGC
Description for AUTO OFFSET and GET OFFSET:
The "GET OFFSET" can use to make the EEPROM copy by PE engineer. When the
PAL and NTSC geometry adjustment had finished, trigger the "GET OFFSET" from "0" to
"1" to store the geometry offset datum between PAL and NTSC in EEPROM.
Chassis Name
Issued on
Updated on
Set the minimal colour when user C olour=0
Set the colour when user C olor=50
Set the maximal colour when user C olour=0
Set the minimal volume when user Volume=0
Set the minimal volume when user Volume=10
Set the minimal volume when user Volume=30
Set the volume when user Volume=50
Set the maximal volume when user Volume=80
Set the maximal volume when user Volume=100
Description
0 EHT tracking mode
25 4:3 mode vertical zoom
0 16:9 mode vertical zoom
1 blanking Switch
5 Wide start
8 Wide blanking end
0 Get offset
61 Cold color temperature R
and G drive offset
56
61 Cold color temperature R
and G cut-off offset t
66
72 Warm color temperature R
and G drive offset
71
65 Warm color temperature R
and G cut-off offset
64
NX56-LA
2008-05-19
2010-01-27
Description
Description
0=EHT tracking only on vertical
1=EHT tracking on vertical and EW
Don't adjust, use default
Don't adjust, use default
0 =OFF,1 =ON
Don't adjust, use default
Don't adjust, use default
64= offset value 0 63= offset value
-1 65= offset value
right value
64= offset value 0 63= offset value
-1 65= offset value
right value
64= offset value 0 63= offset value
-1 65= offset value
right value
64= offset value 0 63= offset value
-1 65= offset value
right value
Serial No.
Page 12 of 15
Page
Version 2.2
Remark
Set the value as
practical
requirement
Remark
Set the value as
practical
requirement
Remark
See below description
1 Adjust to
1 Adjust to
1 Adjust to
1 Adjust to