NetComm NF4V Installation Manual page 41

Some wireless adapters have a 3rd party utility installed which controls the configuration and connection profiles of the wireless
adapter.
In these cases, it is necessary to enable a service called "Wireless Zero Configuration". The steps to do this are listed below:
Click on the Start Menu. Click on "Run", and type: services.msc <and then click "OK">.
1.
2. Scroll down to the bottom of the list and locate the service called "Wireless Zero Configuration" and double left click on it.
Change the "Startup type" to "Automatic", and then check the "Service status" below this;
3.
- If the "Service status" is "Started", click "OK".
- If the "Service status" is "Stopped", press the "Start" button on the lower left side of the window and then wait until the
service has started. When it has, click "OK".
4. Close the Services window.
Enabling Wireless Zero Configuration