Before Starting; Care And Operation Of Compressor - Pioneer Brite Striper 2000 Instruction Manual & Parts List

BEFORE STARTING

The 2000 STRIPER is shipped with engine oil. Be sure to check the en-
closed Operating and Maintenance instructions for proper oil. Follow fill-
ing directions.
1.Carefully read and follow instructions for starting and maintaining
the engine (in a separate booklet furnished with your machine).
2.Check all hose connections and fittings making sure they are tight.
3.Be sure paint tank pump assembly is sealed tightly. Refer to care
and operation of tank unit section.
4.Check to make certain that paint tank is secured tightly.
5.Any fittings, if replaced, should have teflon tape applied before
tightening. Do not force fittings on paint tank bushings. Always
hold nut on paint tank bushing when tightening fittings.
DO NOT TIGHTEN FITTINGS WITH PRESSURE IN TANK.

CARE AND OPERATION OF COMPRESSOR

The piston-type compressor requires minimal maintenance.
Pre-lubricated ball bearings for delivery of oil free air.
APPLYING OIL TO ANY PART CAN RESULT IN REDUCED PERFORMANCE
AND MAY VOID WARRANTY.
The compressor is designed to release pressure at approximately
40 to 45 PSI. If it is not releasing, contact us immediately. You may
have a defective or damaged relief valve. If striper is left idling the release
valve on tank will release pressure.
The air filter (part# 1632) should be replaced whenever it becomes dirty
and/or clogged.
Operate compressor at lowest engine speed practical.
4
MODEL 2000