Trouble Shooting The #2000 - Pioneer Brite Striper 2000 Instruction Manual & Parts List

TROUBLE SHOOTING
Brite Striper
STRIPER DOES NOT STRIPE FULL LINE
1. Was paint strained?
2. Check paint level.
3. Check nozzle screen for clogs. Clean as needed.
4. Check nozzle tip for proper alignment — horizontal.
5. Check operating pressure — is air releasing through safety release
valve on compressor?
6. Check airline hose fittings — tighten as needed.
7. Check pulleys and belt. Adjust as necessary.
8. Check shut-off valve for clogs — clean. Adjust control cable.
9. Check paint line hose for clogs — clean.
HAND HOSE ASSEMBLY DOES NOT
SPRAY PROPERLY
1. Check nozzle, screen and tip for clogs — clean as needed.
2. Check operating pressure.
PAINT LEAKS
PAINT TANK LEAKS PAINT
Check that fittings are tight.
PUMP ASSEMBLY LEAKS PAINT THROUGH CENTER
Check to be sure rubber end on bottom of pump assembly
is not being held open by dry paint.
PAINT LINE HOSE LEAKS PAINT
Check paint line hose fitting — tighten.
NOZZLE ASSEMBLY LEAKS
Tighten nozzle assembly.
SHUT-OFF VALVE LEAKS PAINT
Check that shut-off valve is tightened. Check control cable adjustment.
®
Model #2000
12
MODEL 2000