Pioneer Brite Striper 2000 Instruction Manual & Parts List page 16

AIR LEAKS
PUMP ASSEMBLY LEAKS AIR
1. Shut off machine.
2. Bleed pressure from paint tank.
3. Remove pump assembly and check tank gasket for damage
– replace if needed. Re-seat in pump assembly. Do not overtighten.
4. Check that brass tube is threaded tightly against top of
pump assembly. Also, check plastic cup at bottom of shaft
for excessive wear. Repair with pump assembly and
shut-off repair kit.
AIR LINE HOSE LEAKS AIR
1. Check air line hose for breaks/cuts. Replace as needed.
2. Tighten air line hose fittings.
STRIPER WILL NOT ROLL EASILY
1. Wheels should spin freely – lubricate bearings.
2. Paint line hose and 12' hand hose should clear wheels.
STRIPER USES TOO MUCH PAINT
1. Opening in nozzle tip enlarged.
Replace with new nozzle tip.
2. Tank building too much pressure.
REV 2/08
13