Host List; Wps - Netis WF-2301 User Manual

150Mbps Wireless-N Outdoor AP User Manual
**-**-**-**-**-**ÿ e.g.: 00-22-33-da-cc-bbÿ .
Follow the following steps to set Wireless Access Control:
1. Enable Wireless Access Control, then select save.
2. Add MAC address you want to control in the "MAC address" field (the format is
**-**-**-**-**-**), then click "Add" button, and you will see the MAC address has displayed in
the MAC list.
3. There are two items supplied, "Permit wireless connection for MAC address listed (others are
Denied)" and "Deny wireless connection for MAC address listed (others are Permitted)", Select
the item you want, and click "Save" button.
Note: If you turn on the wireless access control, and wireless access control rules to select the
"Allow wireless connection table in the MAC (MAC-to prohibit other wireless connection)," the
bottom of the MAC access control list does not record, then any host are can not access the
wireless network.

4.3.1.5 Host List

Figure 4-16
All this shows the current wireless access point by access to the state of the wireless station, easy
to manage.

4.3.1.6 WPS

Wi-Fi Protect Setup (WPS) function can let you create a safety network easily. You can through
'PIN Input Config (PIN)' to encrypt your network.
Note:
If you have configured encryption mode in your router, then when you use this WPS function,
please configure the authentication type to none, and then it will be encrypted to WPA2-AES
mode automatically. If you don't want to change your authentication type, then when you use this
function, the router will be encrypted to the mode that you have configured.