Auto Sp→Ep Timer; Auto Timer - JVC HR-DVS2U Instructions Manual

48
EN
Auto SP → EP Timer
(VHS deck only)
If, when recording in SP mode, there is not enough tape to record
the entire program, the VCR automatically switches to EP mode
to allow complete recording. This feature is especially handy
when recording a program of more than 2 hours in length.
For Example . . .
Recording a program of 140 minutes in length onto a 120-
minute tape
Approximately 110 minutes
SP mode
Total 140 minutes
Make sure you set "AUTO SP→EP TIMER" to "ON" at the VHS
Mode Set screen before the timer recording starts.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS VHS MODE SET
SCREEN
2
Move the highlight bar (arrow) to "VHS MODE SET" by
pressing %fi, then press OK or #.
SELECT AUTO SP→EP
TIMER SET MODE
3
Move the highlight bar
(arrow) to "AUTO SP→EP
TIMER" by pressing %fi,
then press OK or # to set
to "ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTES:
If you have programmed the VCR to timer-record 2 or more
programs, the second program and those thereafter may not
fit on the tape if you set the Auto SP → EP Timer mode to
"ON". In this case, make sure the mode is not engaged, then
set the tape speed manually during timer programming.
In order to ensure that the recording fits on the tape, this
feature may leave a slight non-recorded section at the end of
the tape.
There may be some noise at the point on the tape where the
VCR switches from SP to EP mode.
The Auto SP → EP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will work with the
following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.
Approximately 30 minutes
EP mode
VHS MODE SET
S-VHS MODE OFF
VIDEO CALIBRATION ON
PICTURE CONTROL AUTO
FRONT AUX INPUT VIDEO
= AUTO SP=LP TIMER
ON
BLUE BACK ON
NEXT PAGE
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
TIMER RECORDING (cont.)

Auto Timer

When the Auto Timer is set to "ON" the timer is automatically
engaged when the VCR's power is turned off. It is automatically
disengaged when the VCR is powered back on.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS MODE SET
SCREEN
2
Move the highlight bar (arrow) to "MODE SET" by
pressing %fi, then press OK or #.
SELECT AUTO TIMER SET
MODE
3
Move the highlight bar
(arrow) to "AUTO TIMER"
by pressing %fi, then press
OK or # to set to "ON" or
"OFF".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTE:
For safety, when "AUTO TIMER" is set to "OFF", all other VCR
functions are disabled while the Timer mode is engaged. To
disengage the timer, press TIMER .
MODE SET
REAR AUX INPUT VIDEO
OUTPUT1 AUTO
2ND AUDIO RECORD OFF
=AUTO TIMER
ON
=SUPERIMPOSE
ON
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END