Kia 2014 Sportage Owner's Manual page 142

Features of your vehicle
Flashing
Erasing programmed HomeLink
buttons
To erase the three programmed but-
tons (individual buttons cannot be
erased):
• Press and hold the left and center
buttons simultaneously, until the
indicator light begins to flash
(approximately 20
Release both buttons. Do not hold
for longer than 30 seconds.
®
HomeLink is now in the train (or
learning) mode and can be pro-
grammed at any time.
4 50
Reprogramming
HomeLink ® button
To program a device to HomeLink
using a HomeLink
trained, follow these steps:
1.Press and
HomeLink ®
release until step 4 has been com-
pleted.
2.When the indicator light begins to
flash slowly (after 20 seconds),
OHD046306N
position the hand-held transmitter
®
2-8 cm (1 to 3 inches) away from
the HomeLink
3.Press and hold the hand-held
transmitter button (or press and
"cycle" - as described in "Canadian
Programming" above).
4.The HomeLink
flash, first slowly and then rapidly.
seconds).
When the indicator light begins to
flash rapidly, release both buttons.
The previous device has now been
erased and the new device can be
activated by pushing the HomeLink
button that has just been pro-
grammed. This procedure will not
affect any
HomeLink ® buttons.
a single Gate operator programming &
canadian programming
® During programming, your hand-held
® button previously transmitter may automatically stop
transmitting. Continue to press and
hold the HomeLink
hold the desired
steps
button. Do NOT
"Programming" portion of this text)
while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
®
surface.
successful training.
If programming a garage door
opener or gate, it is advised to
® indicator light will
unplug the device during the
"cycling" process to prevent
possible motor burn-up.
®
other programmed
® button (note
2 through 4 in
CAUTION
the